Page 1 of 1

Skorpion Tour

PostPosted: Thu Jun 15, 2006 9:56 pm
by wario
Does anyone else have one? I feel like a lonely stranger. I just bought a 99 in incredible shape and am just having a riot with it. I'd love to find suspension and "flow" mods for the carb and exhaust. The bike came with an M4. I'm considering putting it back on. Any suggestions for next steps? The bike is bone stock.

more toys

PostPosted: Fri Jun 16, 2006 7:45 am
by jimc
Here's a couple of go-fast sources I found, although i suspect the biggest performance improvement would be from the lighter wallet weight....

http://www.zabernet.de:16080/bill/Tuning.html
http://www.hyperprousa.com/
http://www.corsemeccanica.com/mz_skorpion.htm

Note that the Yamaha Raptor ATV has the same top end, there's a bunch of hi performance motor parts out there for that, although I believe you'd have to
change the Igniton to bump up the rev limit.
Another thing I'm looking into is the Magura Hydraulic clutch lever setup , they list the raptor, so the master & slave are correct, but I don't know if the hose is right lengthwise.
Good Luck,

PostPosted: Fri Jun 16, 2006 2:42 pm
by wario
Thanks Jim!

PostPosted: Sun Jun 18, 2006 2:48 pm
by whysub01
Bore it out to 686cc fitting a J&E 102mm piston. Will give loads more bottom end torque and a few more bhp, and without losing any reliablity.

Pistons availablefrom Slipstream Tuning in the UK at around £140 each. Top performance hike for very little money.