MZ/MuZ Riders

I needed a clutch lever for my Mastiff and I scoured the site for info and everyone says mid 90's KTM. I stopped by a dealer and they had an old Duke in for service and the lever was not the same. I also heard early BMW F650's would work. Today I brought my broken lever to a BMW shop and checked. Low and behold they had a lever in stock for a 1998 F650 and it was a perfect match. The BMW part number is 32722345417 and I they are available from any dealer or from A&S online http://www.ascycles.com/SearchResult.as ... 2722345417
Hope this helps someone.

Are the levers the same on the Mastiff and Baghira? Any chance that the BMW brake lever will fit?
Thanks Ed

i will be checking in the next few days as my saxon tour has a bent
brake lever
it and rt125 are same unit
ar dave

Any Yamaha clutch perch should work....or generic clutch perch. Also, I have straightened bent levers after heating them up.

the problem of a clutch lever is easy to solve just replace the whole thing

but the brand of brake master cylinder used on the rt125 and Saxon tour
is a odd one i have not been able to find a lever any where for front brake
but i am sure i saw one on some model of bmw

so the info above has me looking again at the f650 1997 and f650 st

in my area there used to be close to 50 bmw bikes now there are less than 10 the guys just do not seem to buy the new ones
the new bmw is $18,000 my saxon tour was $2000 with 5250 miles on it
and i do not have to take it to dealer to plug it into a computer to fix it


any one with a f650st or 97 f650 out there that can measure some things on there brake lever i can send picture of what needs measured