Carb Breather hoses

[Stuart109]

Hi
I am just putting my Baggy back together but can’t figure out the carb breather hoses.
There are two with a T piece in the middle.
One end goes out the bottom by the swinging arm with a pile of other hoses.
They connect at the carb to a vent between the carbs and a similar one on the right of the carb when viewed from the front, I marked these two.
But where does the third opening connect? Seemed so obvious when it took it apart, but now cannot find anything to connect to.
Can anyone help?
Stuart

[Baggy_Al]

try the vac hose thread,(7 threads below this) there are some diagrams that have been posted, or have a look on grahams m/cycles page -parts section. if thats no help I can have a look at mine on friday in the daylight(no power in garage).

Al.

[OLDMTNCARVER]

Stuart,

This picture is of the hose fittings number 7 and number 9 on my Baghira's carb. Both extend down to the "Tee" (behind the starter) and then continue as hose line number 21.

[OLDMTNCARVER]

Stuart,

This picture shows where hose line number 21 connects to. And as Al noted, look at the diagrams I posted earlier in the 660 forum tread that concerned vacuum lines.

Hope this helps...