I have been rebuilding a 1979 TS-125 Alpine for about 6 months. It is now almost ready to go back on the road but I am getting a lot of blowing between the exhaust and the silencer. I have taken the silencer off, cleaned up the two mating surfaces and clamped it all back up as best I can but there is still some leakage. I suspect one or the other part is now no longer properly round so I am not getting a proper seal.
Can anyone advice anything I can use to make a better seal?
Greg
MZ/MuZ Riders
A community for owners and riders or MZ Motorcycles, Scooters, and ATVs.
TS-125 Exhaust blowing
Moderators: DAVID THOMPSON, phlat65
2 posts
• Page 1 of 1
TS-125 Exhaust blowing
by gregtaylor » Thu Mar 17, 2011 6:43 am
Bikes:
1974 Honda CB175
1979 MZ TS125 Alpine
1982 Honda CB250
1974 Honda CB175
1979 MZ TS125 Alpine
1982 Honda CB250
- gregtaylor
- Posts: 10
- Joined: Mon Mar 14, 2011 10:40 am
Re: TS-125 Exhaust blowing
by Old Dog » Thu Mar 17, 2011 11:55 am
Hi temp silicon sealer will do the trick until the carbon builds up enough to provide a better seal.
Cheap at motorworld - no need for flash exhaust putty or anything
Cheap at motorworld - no need for flash exhaust putty or anything
All the best
Old Dog
He hath no grave, is covered with the sky and the way to heaven out of all places is like in length and distance
Old Dog
He hath no grave, is covered with the sky and the way to heaven out of all places is like in length and distance
- Old Dog
- Posts: 322
- Joined: Mon Mar 07, 2005 4:09 pm
- Location: UK
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 12 guests