Is the UK the only place to get parts?

[daytona]

Lookin for a clutch cable for my 98 660 mastiff! I'm thinkin a Yama Raptor looks close? But will have to order it to see if I'm rite.

[kman.45]

SF Moto in San Fran... sfmoto.com I think.

[iceman]

Make your own http://www.apriliaforum.com/forums/show ... utch+cable

I saw a post not long ago about a place that will custom make them for you.I just can't find it but they are out there.

[MSW]

Motion Pro makes just about any bit you'd want to build your own. Also, one of our own (can't remember whom off the top of my pointy head) has had Flanders Co make them up for him (http://www.flandersco.com). Apparently, once they know the dimensions, they keep a record, so you should be able to just call them up and say "please make me a Baggy/Mastiff clutch cable."

OK, it might take a little more explaining than that, but you know what I mean.

[daytona]

All dead ends so far getting a clutch cable for the mastiff! I "will" find out what works! I have A motion pro coming for a 01 to 05 660 Raptor. may have to route it some other way if its too short but the ends look ok. The clutch side is rite for sure but lever end is?? I must have an after market will fit lever cause it don't have a brass insert like i hear they come with. Mine looks like a XT600 set up. I still got a few of those from my Old tenere that I still miss. I'll post up what I find in the will fit parts thread if it will.

[amahoser]

I replied to your other post in the tech area, but in case you don't check that one,
try flanders again... call them. I know they have the template.... I saw them make up a spec sheet for it using my original MZ Baghira cable. Tell them that I went into their shop and they made a template of it.

Jose Soriano

[daytona]

I replied to your other post in the tech area, but in case you don't check that one,
try flanders again... call them. I know they have the template.... I saw them make up a spec sheet for it using my original MZ Baghira cable. Tell them that I went into their shop and they made a template of it. Jose Soriano

Thanks for the help. But as I was told via PM, to stop waisting time and just order from the folks in the UK! So I did!! What customer service and not a bad price at all! I think we get a discount to offset the shipping? The MUV part is about the same cost as a custom M. Pro. Hope they stay in biz for us MZ/Muz bike owners. Thanks All for the effort!